It is used to support the steel coil and uncoil it in a turntable way. Passive uncoil pulled by roll forming system.

Capacity:  5 Tons

Loading width: Max 550 mm

Valid expanding range for coil inner diameter: 450-610 mm

Adjustable center of the forming rollers and of sufficient length to prevent lateral movement of the strip on its entry to leveling system.

Feeding type: Adjustable

Feeding width range:150-550 mm

Entrance and guide roller: Diameter is￠80 mm

Roller material: SAE 1045, HRC 48-52 surface with chrome

Machine base frame adopt H beam welding steel. In the main roll forming machine have 2 buttons for urgency stop if happen any malfunction. Machine adopt iron cast as station to make machine in strong. To avoid accidents, all of drive part adopt protect cover. 

Drive type: Chain

Roller station: 18 groups

Working speed: 8-12 m/minute

Main motor power: 18.5 kw

Width adjust motor power: 4.5 kw (1.5 kw*3 sets)

Voltage / Frequency / Phase: 380 V 50 Hz 3 Phase

Roller material: Gcr 15 steel and quench treatment hardness HRC 55-58, chrome coated 0.05 mm

The width of the profile can be automatic adjusted by the control computer and the last 10 roller stations can be manual overturned to make C or Z purlin.

The hydraulic cutting machine with good compression performance, good flatness, automatic fixed-length cutting, high degree of automation.

Cutting blade: Cr 12 mov

Cutting tolerance: 12 m +/- 1.5 mm

Cutting type: Hydraulic cutting after forming

Auto cutting when reach the length set on the computer.

The width and height of cutting blade can be manual adjusted .

Table for reception of the cut profiles, there are rollers on the table to unload the cut profile freely.

Frame: Welding by steel angle

Diameter of support rollers: 55 mm

Roller material: ASTM 1045 with chrome

Table size: About 2.0 *0.6 * 0.9 m (L*W*H)

Table color: Blue or base on customer request

It is controlled by gear wheel oil pump. After filling the hydraulic oil into the hydraulic oil tank , the pump drive the cutter machine to begin the punching and cutting job.

Hydraulic motor : 7.5 kw

Hydraulic oil: 46# 60 L

Components: The system includes a set of hydraulic tank , a set of hydraulic oil pump, three hydraulic pipes and three sets of electromagnetism valves.

The PLC (Programmable Logic Controller) powered by the software that controls the automation of the processes of the forming, cutting and punching.

It adopt the latest technology that allow the operator enter all data through a touch screen quickly and reliably to meet a predetermined production.

Voltage/ Frequency / Phase: 380 V 50 Hz 3 Phase

Automatic length measurement

Automatic quantity measurement

Length Tolerance: 6 m ±1.5 mm

Length inaccuracy can be amended easily.

Language: English and Chinese   

Control panel: Button-type and touch screen